Environmental Sanitation Engineering ›› 2024, Vol. 32 ›› Issue (6): 43-49.doi: 10.19841/j.cnki.hjwsgc.2024.06.006

Previous Articles     Next Articles

Pressing Dewatering and Filtrate Quality of Typical Aquatic Organic Waste

WANG Yunzan, ZHANG Lu, LUO Xi, XIE Xiaoliang, LIU Yuru, YU Wenbo   

  1. 1. School of Environmental Science and Engineering, Huazhong University of Science and Technology; 2. Changjiang Institute of Survey, Planning, Design and Research Co. Ltd.
  • Online:2024-12-27 Published:2024-12-27

Abstract: Typical aquatic organic waste Myriophyllum verticillatum samples were pressed at a pressure of 0-10 MPa, and the water content of the dewatered samples and the quality of the filtrate were examined. The results found that when the pressing pressure was 2.5 MPa, the mass of Myriophyllum verticillatum could be reduced by 53.85% and the volume reduced by more than 80%. The COD, suspended solids concentration and total phosphorus content in the press filtrate could not meet the Class III water discharge requirements of GB 3838—2002 Environmental Quality Standards for Surface Water, and further treatment was needed. The protein content could reach more than 200 mg/L, which has certain potential for resource utilization. The organic components of lake water and leachate include protein-like, fulvic acid-like and humus-like substances. Among them, the lake water was dominated by protein-like substances, while the content of fulvic acid-like and humus-like substances in the leachate was significantly higher.

Key words: aquatic plants, filter press dewatering, water quality, quantitative reduction, parallel factor analysis

No related articles found!
Viewed
Full text


Abstract

Cited

  Shared   
  Discussed   
[1] . Status Evaluation of Groundwater Quality of A Waste Landfill Site in Tongliao   [J]. Environmental Sanitation Engineering, 2018, 26(3): 36 -38 .
[2] . Analysis on Characteristics of Stench and Effect of Different Deodorization Processes in Domestic Refuse Transfer#br# Station   [J]. Environmental Sanitation Engineering, 2018, 26(3): 56 -58 .
[3] . Stress Analysis of Steam-water Pipes and Optimized Design of Support-hangers in Waste Incineration Power Plant   [J]. Environmental Sanitation Engineering, 2018, 26(3): 59 -62 .
[4] . Research on Treatment of Water-wall High Temperature Corrosion of Waste Heat Boiler in Municipal Solid Waste#br# Incinerator   [J]. Environmental Sanitation Engineering, 2018, 26(3): 68 -70 .
[5] . Prediction on Generation Quantity of Food Waste in Planning of Kitchen Waste Disposal Facilities   [J]. Environmental Sanitation Engineering, 2018, 26(3): 87 -90 .
[6] . [J]. Environmental Sanitation Engineering, 2018, 26(1): 5 -8 .
[7] . [J]. Environmental Sanitation Engineering, 2018, 26(1): 63 -65 .
[8] . [J]. Environmental Sanitation Engineering, 2018, 26(1): 66 -69 .
[9] . [J]. Environmental Sanitation Engineering, 2018, 26(1): 77 -79 .
[10] . [J]. Environmental Sanitation Engineering, 2018, 26(1): 80 -83 .
Copyright © Environmental Sanitation Engineering
Address: 107#, Weidi Road, Tianjin, P.R.C.    Postcode: 300201
Telephone: 022-28365069   Fax: 022-28365080 E-mail: csglwyjs10@tj.gov.cn
Supported by:Beijing Magtech